• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Spotting bad capacitors

wrightal123

New Member
Hi all. I'm a lurker but a recent second hand purchase of a couple of Sansui hifi bits has got me into the DIY and just starting to learn about electronics (my soldering is currently shockingly bad) A little bit of knowledge is a dangerous thing!

Any way. I could do with help from those who have seen the good, the bad and the ugly when it comes to capacitors. This is a pic in my Sansui G-301 receiver of a capacitor on my tuner side where I get nothing on AM or FM. Does that look like glue (ugly) or does this look like evidence of a bad capacitor to you? No others on the board look like this.
Thanks
 

Attachments

  • 20250331_132352.JPG
    20250331_132352.JPG
    169.1 KB · Views: 70
Register to hide this ad
@avionic sorry for the delay but checked a few times based on what I am about to tell you.

I have tested in place on the board. I get different readings each time: EB gets between 16 and 30mv no matter which probe I place on B. CB (I presume the 3rd leg is C) get O volts no matter which way round I probe. I also get the same mvoltage across CE. I am new to this so watched a few vids and summise that TR19 has gone :) I checked with both probes on base as don't know if it is an NPN or PNP. TR19 has the description 2SD438 but whereas the schematic shows the Fig attached (2SD438 E, F) - the actual transistor is the expected 3 pin jobby in the photo attached. From the Photo you can see the right leg is B. The left leg is E. I am presuming the middle leg is C.

I looked up a datasheet on the 2SD438 which shows it is an NPN and suggests the EB max voltage is 5V but there is also a max CE of 80V and a max CB of 100 V. I am suprised to see a CE voltage as was expecting this should not happen with my extremely lacking knowledge.

Any comments, except "pack it up you tw8T" are most welcome. Thanks.
1743541788278.png20250401_221916~2.JPG
 
Thanks @petehall347. I got the datasheet elsewhere but now can see that the BEC positions are as I described on this . Just confused by the graphic on the Sansui service manual showing the strange looking 2SD438 fig I posted above. I swear right now if someone asked me for a left handed screwdriver I would ask them 'slotted or phillips'.
 
Arrgghhh! Is it against forum rules to insult myself and apologise to those trying to help me. Nothing you can do when dealing with a muppet like me!
Jusr realised @avionic that I had the incorrect setting on my multi meter. The readings are:
BE > 0.594
BC > 0.586

I think that is what should be expected?
 
The readings are:
BE > 0.594
BC > 0.586
Those are good for an NPN with the red lead on base and the meter set to diode mode. It should read OL or open with the black lead on base.

An easy way to help identify the pinout on a TO-3 style transistor is to remember the Case is always the Collector.
 
Last edited:
Back
Top Bottom