SR 4000 power switch gone bad

[guitar_freak]

I have a Marantz SR 4000 and the power switch had gotten stuck in the ON position. After much lube and tinkering I figured I may as well save the money, take the switch apart and clean it up. (These are not built to be taken apart) Anyhow I can't reassemble this switch.

Looking on eBay i can only find 6 pin Marantz power switches. can i make this work? My power switch is only 2 pin.

 

[petehall347]

depends firstly if it will fit and secondly if it can carry the same current .

 

[EastPoint]

The six pin switches will work fine as long as they fit. They are pretty cheap so I would probably just buy one and go from there.

 

[guitar_freak]

The six pin switches will work fine as long as they fit. They are pretty cheap so I would probably just buy one and go from there.

what pins do i use on these switches?

 

[EastPoint]

Ignore the two front pins. Bridge the back left to the back right and the middle left to the middle right, and attach the receiver wires to the back and middle.