thrasher13
New Member
Hey guys,
I'm looking to completely replace the turntable in my Zenith F904P console stereo. The radio/amplifier works fine. As I was cleaning out the back and pulling the old turntable I noticed that it basically controls its own power. You set the radio to Phono/Off and then powering the amp on/off is dedicated to the switch on the turntable. Power comes from three wires orange, yellow, and gray. Attached is an image of the wiring the runs to the old turntable and one of the unit itself. Does anyone know how I would go about wiring this up to a new turntable's power supply and controlling the power from the new turntable?
I'm looking to completely replace the turntable in my Zenith F904P console stereo. The radio/amplifier works fine. As I was cleaning out the back and pulling the old turntable I noticed that it basically controls its own power. You set the radio to Phono/Off and then powering the amp on/off is dedicated to the switch on the turntable. Power comes from three wires orange, yellow, and gray. Attached is an image of the wiring the runs to the old turntable and one of the unit itself. Does anyone know how I would go about wiring this up to a new turntable's power supply and controlling the power from the new turntable?