New profile posts

2/2 update ….The Denon has the ability to turn off the equalizer. It’s in the instruction manual, but I don’t know where the SWITCH is as I don’t have physical access to a turntable like that. You might have to remove the platter and poke around a lot to find it. But in any case, that seems to be the issue, as by default, it is turned on.

1/2 update - Look in the manual for the Denon, there is an equalizer switch that you need to turn off, and then you can use it with the phone input on your Mac 1700. I had a look at the schematic, you would have to modify the Mac by removing two resistors. I don’t recommend that actually.

Try plugging your Denon directly into AUX because it apparently does have a built in preamp according to Denon product page.

I am in Towson, Maryland. Unfortunately I do not drive so my ability is limited to the immediate Towson area. Here are pictures of some of my children. LOL!

Hey! I recently got a SUV98 with this remote control (see photo), do you have any idea which VCRs are copatible with the controler. And my last question is about the remote control from the EQ SH 8057 from the 88'; it has a remote in and out plugs, any idea if I can control the EQ by following the whole control system (deck, tuner, amp, etc). I'm trying to build the SC A870 Technics Rack from US around 88-89!

Hi Mcaddie7-

I was reading your HK 930 restoration thread with interest. I have a 930 that is new to me. I am unable to set the bias. I have the left channel set to ~15 mV. But the right channel is between 50-60 mV regardless where I set (VR621). I see in the thread that you changed VR601 and VR624 potentiometers to new ones. What potentiometers did you use to replace VR601/621 and where did you source them?

Thanks

Can you make a wooden cabinet for a sansui 3000A reciever and if so ,what will it cost me

RIP SEOTL - 2024. This member's memorial information can be found here: AudioKarma's Memorial Wall

Hello. I just bought a pair of 322c and am designing a box for them based on the 2.4cu. ft. from the matched JBL product. This volume seems a bit big. Did you have any luck on this project? Any insights are appreciated. Thanks.

Hello. I just bought a pair of 322c and am designing a box for them based on the 2.4cu. ft. from the matched JBL product. This volume seems a bit big. Did you have any luck on this project? Any insights are appreciated. Thanks.

I am debating if i should repair my ess amt i towers, I need the best 10 inch woofer, I read need a fast woofer the freq res of the towers were 28-24k =- 2.5 db

Just acquired Sansui 5050 receiver and it takes 25 second for the speakers relay to click and it sounds good in my opinion. Is it normal that it takes that long?

5000A,220071075,jd3rdcoast

Thanks for the reply
I didn’t realize that I could install a two channel receiver, cause I was thinking being that I had four speakers the only way to separate them would be to use something with at least four channels plus the sub?
I know nothing