• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

bridged

  1. Megaladoink

    2 X Carver TFM-15CB ‘s How would I set these up?

    I have been using a Carver TFM-15cb Power Amp hooked up to my Carver CT-17 Speakers are Klipsch Quartets. I’ve got it daisy chained to some Vandersteen Model 2. For those asking, all hooked up to a Bang & Olufsen 4004 Beogram. I would like to get more sound out of the vandersteens so I bought...
  2. Andrew Heck

    Bridging Parasounds

    In my present system I’m driving 150w speakers with a 100wpc power amp. I run my power amp wide open and control volume with my preamp. When I am really pushing the volume, the preamp potentiometer sits at 1 or 2 o’clock and I’m worried about inaudible clipping damaging my speakers. What I...
    • Andrew Heck
    • Thread
    • bridged bridging amps clipping parasound power power amp
    • Replies: 27
    • Forum: Solid State
  3. K

    NAD 2150 Bridging problem - pulsing sound

    I have just implemented bridged mode on my NAD 3150 and 2150 to drive my Magneplanar speakers. However, after the system is on for several minutes, a low-frequency pulsing sound starts up in the left speaker (driven by the 2150), pulsing at about 150 bpm, though it speeds up and slows down a bit...
  4. Raphaz

    Two receivers connected – one used as power amp?

    I currently have a Nikko NR-1219 receiver hooked up to a pair of KEF Q500's and a KEF PSW 2150 subwoofer (the latter run through Pre-out/Main in). I listen to vinyl, CD's and streaming/mp3, in a large loft space with heigh ceiling. I own another receiver, the Yamaha R-2000 which has a lot more...
    • Raphaz
    • Thread
    • bridged combination recommendation hook up kef psw 2150 kef q500 nikko nr1219 receiver advice receivers setup yamaha r-2000
    • Replies: 1
    • Forum: General Audio Discussion
  5. M

    mtx soundcraftsmen s800 bridging kit

    I want to bridge my s800 amp, but the manual says it needs a bridging kit. Does anyone have one of these? A schematic would be nice. CAn I bridge this amp without a kit. What exactly would the kit do?
  6. camerakid

    Can The SMSL SA-50 Be Bridged?

    I was thinking of getting an SMSL SA-50 amplifier with some of my Christmas money, but can it be bridged? I want to use it for testing speakers I get from the thrift, and I also want to use it for a small subwoofer in my house.
Back
Top Bottom