• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

fuse lamp

  1. david winter

    Luxman M-2000 fuse lamps: adapting 6.3V models for 10V operation

    Hi, This amp uses longer fuse lamps of 45mm. As 41mm ones also fit, I wanted to know if someone used the common 6.3V fuse lamp. This one shows a 270 ohms resistor on the bottom side of the pcb, so I wondered if replacing it with a 430 ohms (or so) would do the trick. Or whether there is a 10V...
  2. J A

    KR-4070

    I'm in the process of refurbing a kr-4070. This is the first time I've done any sort of vintage audio refurbish at all but it was a good deal and I have a KD-5070 so I thought I'd just have a Kenwood setup for fun. Anyway, I'm ashamed to say I basically picked it up and before even taking any...
  3. sKiZo

    Dial lamp replacement

    Deserves a sticky I think, considering some of the convoluted "Chinese Puzzle" hoops they make us jump through to get er done. Normally, the fuse lamps will still work, but go intermittent due to cracking solder joints on the lamp holders. Too many hot/cold cycles over time, and it happens. My...
    • sKiZo
    • Thread
    • dial lamps fuse lamp lamp holder replace dial lamps sansui
    • Replies: 1
    • Forum: Exclusively Sansui
Back
Top Bottom