• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

kenwood ka-3500

  1. TomTom4049

    Kenwood KA-3500 hum problem through speakers (not transformer)

    Had a problem with one of the batwings so I replaced them with the recommended OnSemi replacements suggested by SilverFace. Except for distortion in the right channel it was working. I discovered when I pressed down slightly on a new capacitor C14 the distortion went away for a few minutes. I...
  2. Super Noob

    Project: Kenwood KA-3500 (Nate Dogg)

    Well - here goes another rebuild thread. In the last month or so, I succumbed to pressure applied from that other person living in my house. I listed a few of my pieces for sale locally on my wifey's face space marketplace. Needless to say, we didn't get much interest in the pieces listed...
  3. ironzo

    Facebook Marketplace score!

    I just picked up a Kenwood KA-3500 amp, a Kenwood KT-5300 tuner, a pair of Kenwood LS-405C speakers, a Kenwood KD-44R turntable, and a Technics SL-D2 turntable, all for $120. The amp and tuner appear to be in good over all condition, but they are pretty dirty. It might be nicotine, but I'm not...
  4. H

    Kenwood KA-3500 loose ground wire?

    I trash picked a ka-3500 with several issues-- but first--there are three black wires attached to pin 3 on the power amp board: one runs to pin 21 on the large preamp board, one runs to pin 10 on the main amp board, and where does the third go? It is long, and I assume goes to the back right of...
  5. Stink Bear

    KA-3500 blowing fuse

    I just acquired a KA-3500, the previous owner said that it keeps blowing fuses. I took the cover off and looked around, there has been something spilled in it at least once. I did a little cleaning so I could see the components better, I don't see anything that looks burnt. I used an ohmmeter...
Back
Top Bottom