• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

output board

  1. david winter

    Kenwood KA-5002 - Correct schematic (or compilation of known variants) ?

    Hi, I have an early KA-5002 (serial 250498) which doesn't match the two schematics that I have. I noticed the following differences : - A completely different protection board under the chassis: smaller, no ref, only 4 transistors (of which two 2SC1213, one 2SC883 and one 2SA537A). No schematic...
  2. JamesWest...

    Channel output Issue Marantz 1150

    Hello dwellers of the Marantz subforum. :) I am seeking knowledge about a Marantz 1150 (not the D model). This amp is a friends, and they asked me to take a look at it. I have a rudimentary knowledge of electronics (mainly tinkering with them for fun) and can solder confidently. A bit of...
  3. AshhBoy_

    dbx cx3-mkI faulty channel repair

    After having my cx3 fixed because of a dead right channel on arrival, I used it daily for about two years with mostly no issues. Two days ago, I fired it up to discover my right channel was presenting a large ac-synced humming noise. I quickly unplugged everything and checked all my wiring, to...
  4. W

    SX-3800 repair

    I have checked every component on the power supply and audio output boards. Replaced numerous blown resistors, a few caps and the output transistors. If I run it without the output transistors connected, I hear the relay click and the DBT has a dim glow. When I connect the output transistors the...
Back
Top Bottom