• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

pioneer 950

  1. C

    Pioneer SX-950 newbie help.

    I recently acquired a Pioneer SX-950. I opened it up to clean all the dust and pots. I was only able to access the volume and balance pots. DeOxit helped a lot to get all the scratchy sounds and intermittent audio issues fixed. I noticed my tuning meter wasn’t moving. I noticed when I jiggle...
  2. kissisone

    Service needed in Michigan - Crossed Paths Vintage??

    Looking for someone to service/repair Pioneer SX 950 in Michigan. (SW Michigan if possible) Any suggestions would be appreciated,
  3. P

    Pioneer SX-950 Phono Section

    The volume level on both phono sections of an SX-950 have very low signal input. I have to turn the volume level to over 50% to get to a low listening level similar to other inputs at 25%. Any insight into a specific cause? Can an external phono section be used and plugged into the existing...
  4. Jcamp

    Pioneer SX-950 Repair

    Hello, I need some help with a SX-950. I received it with the following components blown Four power transistor - Replaced all with "original" 2SB557/2SD427 from eBay Both 2SB536 One C1628 Both Bias pots blown 150 ohm R40,R39 I have replaced these transistors 2SB536 with KSA940 2SD381 with...
  5. MAG_1944

    Pioneer CT-F950 issues

    I've recently purchased my first vintage cassette deck, a 1979 pioneer CT-F950. Having set it up and run a few tapes, there are a couple of things I have noticed and I'd like a little bit of advice on: Before I ran it, I cleaned the head, roller and capstans with some IPA. There is a pop...
  6. Super Noob

    Project: SX-950

    Here comes my latest rebuild... local SX-950. https://drive.google.com/open?id=1qMku989EUw8sRdkSVOmchybrtVHA-dwv The caps lists was a copy from MTF / MattSD... it has some errors but may be a good starting point for someone who might attempt a rebuild. I recommend the following = new...
Back
Top Bottom