• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

speed issues

  1. C

    Pioneer RT-707 Servo Board Troubles

    Hey all, I'm trying to get an RT-707 back into shape. It had been worked on before, caps that see the most usage have been replaced and the problematic small signal transistors that keep up the recording bias have been replaced with modern subs as well. It doesn't response to any speed...
  2. EmbyrMusic

    Sony PS-LX2 45RPM Problems

    Hello all! I recently purchased a Sony PS-LX2 Direct Drive turntable. Everything appeared to be working perfectly at first. 33 RPM works without any hiccups. However, when I put a 45 RPM record on, it was running at about only 37 rpm. So I found the service manual for the Sony PS-LX3 (Very...
  3. Jason Covert

    Runaway Speed Issue with SL-Q303 - AN6680? IC101?

    I have a runaway speed issue on a SL-Q303: when the start/stop button is first depressed the table will speed up and never look back. Nothing changes when you change the speed selection (33/45). When you press stop, the tone arm will whip back into resting position (likely being powered by the...
  4. ClayTune

    Brand new AT-LPW40WN, speed issue.

    Hello all, I really wanted to try out a decent starter Belt drive turntable. So I did a fair amount of research, as well as watching youtube reviews and reading amazon reviews. I landed eventually at this model, which has about a 90% approval rating from Amazon and only one specific post...
  5. kylemac

    Help! Pioneer PL-5 turntable spins in reverse

    Folks, I rescued a Pioneer PL-5 turntable from the pawn store last week.... used, but in the original box with a decent Stanton Gold cartridge on the tonearm. While the box said "tested," I accepted it was not. For $50, I took a shot, as I hate to see vintage electronics go to places where...
  6. Chriswashere

    Gates broadcast turntable problems

    Hello, I'm trying to repair a Gates broadcast turntable for a friend, and I just can't figure it out. The table runs at the right speed a few minutes after power-up, but as time goes on the table gets slower and slower. It has a new idler, so what else could be the issue? I believe it is a...
Back
Top Bottom