• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

troobleshooting

  1. S

    Harman Kardon Citation 17 troubleshooting

    Hello all, Im trying to figure out my Citation 17 preamp, I had everything recapped and resistors replaced to 1% metal film around 10 years ago. the power supply has 16v on the 15v rails right now. does anybody know what resistor to modify to get this into spec? also one of my EQ boards is only...
    • streetwise
    • Thread
    • circuit board help citation 17 harman kardon troobleshooting
    • Replies: 7
    • Forum: Solid State
  2. SDup

    Help Troubleshooting Audio in One Channel Only + Hum

    I was listening to a record on Friday when the audio decreased suddenly. I checked my setup (description below) and I noticed that the left channel was dead. When I use balance to isolate it I get a hum (loudness increasing with volume) and when I turn the volume up to at least 50% I can hear...
    • SDup
    • Thread
    • channel failure dead channel hum in left channel hum in phono stage troobleshooting
    • Replies: 2
    • Forum: Turntables
  3. galactech

    Strange Noise coming out of left Speaker after reciever is powered off?

    Speakers: Bang & Olufsen Type M Passive Loudspeakers Reciever: Sansui QRX-4500 Turntable: Project Debut Carbon Hey all, recently I’ve noticed that after turning off my reciever, my left speaker makes a consistent/replicable noise after 10 seconds or so. It only lasts a few seconds, but it’s...
    • galactech
    • Thread
    • bang & olufsen loudspeaker repair speaker advice troobleshooting
    • Replies: 6
    • Forum: Speakers
  4. Edwards1

    Sanyo TP 1005 turntable platter does not spin

    Hi. I bought a Sanyo TP 1005 turntable for Ebay a few weeks ago. The TT was well packed. When I took it out of the box I noticed the platter did not spin. The belt is brand new. The servo motor does work but it does not make the platter turn. The platter itself does not move freely. It seems...
    • Edwards1
    • Thread
    • sanyo troobleshooting turntable
    • Replies: 1
    • Forum: Turntables
Back
Top Bottom