• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

2220B restoration thread

A complete recap list for this model would be very nice. My 2220B sounds good but I think it would be a good first time project for recap. I am of course a little nervous about the whole "how will it sound when done issue".

Check the polarity of every cap you replace. Be careful in there, and take your time. I got in a hurry on this one, and screwed it up. Took a hell of a long time to fix everything. Oh well, that kinda crap happens when you're just learning.
 
I just got a 2225 that has the same look on the inside as yours did. I noticed yours cleaned up quite nicely. What did you use to clean it? What procedure do you use to insure no sparks when turning it on for the first time after cleaning? Thanks.
 
I just got a 2225 that has the same look on the inside as yours did. I noticed yours cleaned up quite nicely. What did you use to clean it? What procedure do you use to insure no sparks when turning it on for the first time after cleaning? Thanks.

Compressed air in a can to remove the loose dust. Then 91% isopropyl alcohol, an acid brush, and lots of Q tips. I just let it dry for a half hour before firing a unit up after cleaning.

Now if you are firing a unit up after replacing major parts, it is advisable to use a dim bulb tester.
 
Dim bulb tester. What's that? The thread is intresting and the idea of recapping is something I'm considering. I took some electronics classes about 20 years ago and have done some soldering. I assume the wick is used to remove the old solder from the board. And the polarity, I guess it is marked on the old and new caps? How hard was it to gain access to the boards to do the work? Thanks for the info.
 
Here ya go - http://www.audiokarma.org/forums/showthread.php?t=223061. Build your very own dim bulb tester. This looks like a good link for DBTs also- http://www.ppinyot.com/dimbulb/dim_bulb_tester.htm. A DBT is just a current limiting device, if there's a short in your receiver, the bulb will light, keeping large amounts of current from damaging your unit.

Practice on some old computer boards to hone your soldering skills. Keep your iron's tip clean, use good solder, and be patient. I prefer a solder sucker for desoldering. Wick is for cleaning up what the sucker doesn't get. Electrolytic caps are marked for polarity. Note that Marantz boards are also marked with polarity, make sure that they are right before you rely on them. I've seen boards with wrong markings.

I don't recall any difficult access in the 2220B. By the way, if you replace the filters, do 'em how I did in the 2245 - http://www.audiokarma.org/forums/showthread.php?t=338638
 
Back
Top Bottom