• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Horn Driver Restoration

MacMan10-100

New Member
So I'm deep into restoring a set of Speakerlab 7s. When I bought them they were a mess. Foam was shot, pots hard to turn, caps leaking & had been changed out w/ junk. The soldering looked really bad, some wires looked just wrapped together.

I'm working on the horn driver now & next up is the tweeter. I got the 3 pins out of the driver housing but still can't get it apart. Is it threaded & screws together? If not how does it go together so I can take it apart?
 
Register to hide this ad
Back
Top Bottom