Pickering is a name you see quite often when doom scrolling and unicorn hunting across the Internet and you're saying, don't do anything too crazy anyway. I've never replaced a stylus. At least not in recent memory so this may be a more affordable way to see if I'm gonna make a mistake or not.
KLH Model Twenty Four 24 What model Garrard Turntable is this?
- Thread starter redpackman
- Start date
Grab the red plastic part (or whatever color it is) and gently pull straight out. Nothing to it. Other cartridges may be different but many do just pull straight out the end. Some pull downward, others are not replaceable at all. Mostly thats moving coil stuff though.
I may be confusing my references. I believe I just replaced the cartridge on my Dual 1219 by taking what I think of as a cartridge and just plugging the whole thing in underneath the head and into the tonearm, then locking the whole thing in place by moving the little lever over on the head so it's perpendicular. The stylus I think if as a fancy name for a needle and that's something I don't recollect ever doing. Ur must be possible if all that's wrong with the cart is that the diamond or sapphire finish has worn down.
KentTeffeteller
Gimpus Stereophilus!
The KLH 24 Garrard changer had the 4 pole motor factory fitted. If I were going to try to fit a AT-6, or an AT-60 motor, I'd service that changer fully, instead, as necessary, and replace the whole changer. Also it would mean in good order, you could track at 2.5 grams, properly adjusted. Which would mean you could lighten tracking force to 2.5 grams, the Stanton 500AL heavy duty stylus would be an upgrade. (Henry Kloss would also have approved of this).
The KLH 24 I had was definitely not a 4 pole motor like my AT6 has. Maybe someone changed it, I don't know, but it had no obvious signs of wires being spliced or anything of that nature.
I'd keep the stock one for cosmetic reasons. The white plinth and body look right with the white controls. The stock tracking force is adjustable to some degree as well.
I'd keep the stock one for cosmetic reasons. The white plinth and body look right with the white controls. The stock tracking force is adjustable to some degree as well.
orthophonic
Super Member
I have had three KLH 24's, they all had four pole motors. There is no need to replace the changer, it will easily track down to 2.5 grams with the proper stylus. And as mentioned, the cosmetics were meticulously matched.
I also do not feel the AT6 and such would be an upgrade due to the very poor arm geometry, which was corrected on the the 3000 and the KLH version had a much lower mass.
The only problem the 3000 had was lesser quality control, ie one sample might run right on speed and another might run slightly fast ( but can be corrected).
I also do not feel the AT6 and such would be an upgrade due to the very poor arm geometry, which was corrected on the the 3000 and the KLH version had a much lower mass.
The only problem the 3000 had was lesser quality control, ie one sample might run right on speed and another might run slightly fast ( but can be corrected).