I am rebuilding the power supply board (p800) on my 2216.
I bought a 5600uf/63v to drop into the 4700ug/55v in position C803.
It had a "dummy Lug" with 3 spots. The diagram indicates the + to - span (see pic).
My new capacitor won't span that. Leads are wide enough.
It will span from pos to the bottom hole, which seems to be the same circuit? If I'm reading the board right, the Green is the path, and the lines break that path.
So is it ok to go from north left open hole to south left open hole instead of the right one as shown by the bridge?
I bought a 5600uf/63v to drop into the 4700ug/55v in position C803.
It had a "dummy Lug" with 3 spots. The diagram indicates the + to - span (see pic).
My new capacitor won't span that. Leads are wide enough.
It will span from pos to the bottom hole, which seems to be the same circuit? If I'm reading the board right, the Green is the path, and the lines break that path.
So is it ok to go from north left open hole to south left open hole instead of the right one as shown by the bridge?
