• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

Need help ID'ing Audax/Polydax driver

Radfordman said:
Will do a similar photo of mine in a few min.

Terrible photo, butthe markings can be seen. These were bought new by me many years ago.
Click to expand...

Remove the Polydax sticker from mine and they look the exact same.

Mine must have been incorrectly stamped with 8 ohm instead of 4 ohm. Or incorrectly wired to 4 ohms instead of 8 ??????
 
Pneumonic said:
Remove the Polydax sticker from mine and they look the exact same.

Mine must have been incorrectly stamped with 8 ohm instead of 4 ohm. Or incorrectly wired to 4 ohms instead of 8 ??????
Click to expand...

Incorrect stamping, I think that is the most likely thing. Yours are the 4 layer coil as well (well I think it says 4C) perhaps that is wrong as well.

Just a thought, have you checked your meter on something else?
 
Radfordman said:
Incorrect stamping, I think that is the most likely thing. Yours are the 4 layer coil as well (well I think it says 4C) perhaps that is wrong as well.

Just a thought, have you checked your meter on something else?
Click to expand...

Yep, kinda tough to see in the picture but magnifying glass shows it to be 4C as well.

Been doing some other work so know the meter's fine.

Stamping issues aside, I'm obviously pleased these all turned out to be 4 ohm units.

Now, I'm ready to go with this project. Re-paint the cabs, work on the x'overs, re-foam the woofs, tighten and re-glue everything up, re-grill em and have a go at them.

-Kerry
 
Probably store my 8" Audax bextrenes for another 25 years! lol.

As mentioned got two sets of Tangent RS2 and two sets of Tangent RS4 with good ones in.
 
Pneumonic said:
Yep, kinda tough to see in the picture but magnifying glass shows it to be 4C as well.

Been doing some other work so know the meter's fine.

Stamping issues aside, I'm obviously pleased these all turned out to be 4 ohm units.

Now, I'm ready to go with this project. Re-paint the cabs, work on the x'overs, re-foam the woofs, tighten and re-glue everything up, re-grill em and have a go at them.

-Kerry
Click to expand...


What happened? Did you fill the woofer cabs with the magic gas?
 
You must log in or register to reply here.
Back
Top Bottom