• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Phase linear 300 resistor question

Chriswashere

Active Member
Hello. I am about to replace resistors r101 and r111 on the driver boards of a phase linear model 300 but the manual doesn't say how many watts the resistors are. They are 3.3k ohms but other than that it says nothing.

I discarded the old burnt resistors a long time ago so I have no way of knowing what exactly they were.

Thanks in advance!
 
Register to hide this ad
If you look at the assembly drawing in your service manual it annotates that all resistors are 1/2 watt +/- 5% carbon film unless otherwise stated. The four resistors R101 and R111 (left and right channels) fall in this category. Hope this helps.
 
If you look at the assembly drawing in your service manual it annotates that all resistors are 1/2 watt +/- 5% carbon film unless otherwise stated. The four resistors R101 and R111 (left and right channels) fall in this category. Hope this helps.

Navo to the rescue
 
If you look at the assembly drawing in your service manual it annotates that all resistors are 1/2 watt +/- 5% carbon film unless otherwise stated. The four resistors R101 and R111 (left and right channels) fall in this category. Hope this helps.

Thanks. I guess if I paid closer attention I would have caught this.
 
Back
Top Bottom