Pioneer CT-F1000 and CT-F950 Feet

[Pharssa]

Hi,

Both of my cassettes decks CT-F1000 and CT-F950 are missing feet. I don't use them in a rack; so, would like to replace the missing feet. Are there any generic plastic / rubber feet (similar to original parts in appearance) that would fit? Looking for suggestions before posting a WTB for original feet from parts units in the Bartertown forum.

Thanks,

 

[Watthour]

Penn Elcom offers various types and sizes of rubber feet. A quick search should reveal a source or two.

http://www.pennelcomonline.com/SearchResults.aspx?Search=feet

 

[blhagstrom]

A good hardware store may have something. Large Ace hardware stores have good selections from what I've seen.


If the holes are for machine screws you will need metric screws.

 

[Pharssa]

Hi Wattthour, thanks for link. I am guessing a 20 mm height rubber feet may work.

Hi blhagstrom, according to the service manual, the screws are tapping type. I will also try the local hardware stores.

Thanks,

 

[miklemke]

Yes, Ace Hardware stores have a good selection on rubber feet. That's where I go.

 

[Pharssa]

Picked these plastic feet yesterday from Ace hardware just to test them along with some 4x10 (CT-F1000) and 3x10 (Ct-F950) Pan head tapping screws. Strangely, the 4x10 screws tuned out to be too thin for Ct-F1000 but fit well on CT-F950. The feet though a bit narrow fit well on CT-F950. Now, need to figure out the right diameter of the screws for Ct-F1000.

 

[Daunia 70]

Most vintage feet will fit as long as the screw size is the same width. My Pioneer Spec 1 pre-amp came with no feet,so I unscrewed four off an old AKAI cassette deck which fitted perfectly.