• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Sansui Six doesn't light up

aileenamegan

Super Member
Got a Six 2 days ago. So far its playing, FM is a bit weak.

But I have no lights on - although all bulbs of the dial scale are new. not the right 6,3V ones but 8V. Also no tuning light (new bulb), no pointer, no sources bulbs - nothing. I can't see, where the source of the evil is. There doesn't seem to be a direct fuse for all the bulbs. But there are four fuses on board F-1456 where I have no idea what they are for.
The service manual is at HiFi Engine available.
Does somebody got a straight tip for me?

Peter
 
Register to hide this ad
Aren't those lights wired in series? Follow the wires to where they connect to a board and see what voltages you get, if any. I think the source is on the left behind the tuning indicator. I'm not a tech though - so take everything I say with a large grain of salt.
 
check AC volts at the blue wires on the transformer . 5.6v
fuse is 0.5amps
this is the same winding that powers the mpx via a half wave rectifier (one diode )
my bet is the fuse is blown
 
Also just because a fuse may "look" okay- does not mean they are okay. More than once I have checked fuses that "Looked" okay, but had broken contact just beneath one of the metal ends.
 
I will check this. Those mentioned fuses I didn't check at all as they are soldered in and have some kind of hose over it.
 
It has been one of the cobered fuses. F1 - where the blue cable went to from transformer. Changed this 5A fuse and now the lights are burning again. Took out the 8V lamps and put 6V in. One holder has been broken. Fixed the lamp on one side with solder. Pointer needle needs to be replaced.
The yellow coverage of the FM-lamp (lamp cabinet/housing) is burned, black. No idea where to get spare from, some kind of DIY material should do it. Or I will take some plastic from a packing and will paint it with a kind of clear yellow.
Meanwhile I washed the Six and she is now outside for drying.
 
Schematic calls for and current draw requires 5 Ampere. There's a single rectifier between all the pilot lamps and the MPX lamp. Check that .. it ties to the blue secondary of the Xformer.
 
Back
Top Bottom