• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

Yamaha p2200 peak meters

C

chris666

New Member
Hi folks,

I noticed that the peak meters are not moving at all to the music.
Sometimes when I first fire it up, they are responsive, and then quit again.

The amplified signal is fine and unaffected. The dials works as they should etc.

Any information would be appreciated.
Thanks!
 
Register to hide this ad
Further info:

left side was working well for a while today, right side barely moving. Panned left and right side became more responsive (strange since all signal was going left) panned right and nothing from left or right.

after a while, both stopped again.






QUOTE="chris666, post: 13651570, member: 168746"]Hi folks,

I noticed that the peak meters are not moving at all to the music.
Sometimes when I first fire it up, they are responsive, and then quit again.

The amplified signal is fine and unaffected. The dials works as they should etc.

Any information would be appreciated.
Thanks![/QUOTE]
 
you definitely have issues that need correcting, But Yamaha meters were never very accurate with dynamic signals. I liked the sound they produced and installed quite a few of them until we discovered QSC which were designed to fit in with more veried professional applications.
 
@chris666

I think if you poke around on this forum or the Internet you will find some information about the meter problem.

As I recall, there is a meter driver module. What I don't recall is if there is one for each meter or a single for both.

Anyway, the point is to check/reflow the solder connections of the meter driver module(s).
 
whoaru99 said:
@chris666

I think if you poke around on this forum or the Internet you will find some information about the meter problem.

As I recall, there is a meter driver module. What I don't recall is if there is one for each meter or a single for both.

Anyway, the point is to check/reflow the solder connections of the meter driver module(s).
Click to expand...


Thanks everyone! I opened it up, touched the solder gun on some points, cleaned it up and it works!
Appreciate the help.
 
You must log in or register to reply here.
Back
Top Bottom