• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Light Show from my Gold Lions, sucks

Freo-1, I haven't seen anyone here from the depths yet. Are you SS then?
Us squids gotta stick together. :D
The Guardfish started out tube driven. That seems cool today but I'll bet a PMS nightmare back then.


..

Indeed I am. Spent 22 years in Uncle's Canoe Club. When I was on Guardfiish, she had tubes in parts of the AN/BQS-6 Sonar.

Still work on the Civilian side, but primarily support the Royal Australian Navy. Occasionally go down under and work/ride their platforms.
 
He's not suggesting you use solid state diodes as a replacement for the 5AR4. He's recommending you install the diodes in series with the 5AR4. It seems to reduce or eliminate the likelihood of rectifier arc over.

The slow start characteristics of the amp are completely unaffected by this mod. It shouldn't have any effect on the normal B+ voltages either. I'd also imagine there is no chance of any audible effects due to solid state diode switching. You can't have any reverse current, even during the couple nanoseconds it takes for the diode to switch, because the 5AR4 is between the diode and the first cap.

Good rectifier tubes are expensive. This seems like cheap and easy insurance.

Thanks for the enlightenment Ty!

Thanks to HifiCanada for the tip. :thmbsp:

Learn summin' new everyday. :yes:
 
Thanks Ty, Sorry I was not clear on the explaintion, just got up from a nap. The KT88 Golden Lion Series are in all four of my MKIII's and they are not that much more in cost then the KT88, JJ's that I have bought first. I got all mine from Jim Mcshane, fairly reasonable and are run and tested before I get them.
Cut the red wires off pin 6 and 4 ,I would not try to desolder them, pulling on the tube terminals to much, crimp the diodes around the terminals, solder the red wires back on to pin 7 and 5 and just solder the diodes in from pin 7 to 6 and pin 5 to 4, make sure the the diode bands are pointed to pin 6 and the other to pin 4.
When finished put the 5AR4 tube back .
 
Last edited:
Back
Top Bottom