• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

c32

  1. mike@itx

    McIntosh C32 Pre Amp

    Hello all, I'm starting a refurbishing job on a C32, the left input won't work. Any ideas will be appreciated. I'm thinking on replacing all the electrolytic caps and the analog switches + op amps also replacing all the cables, Thanks, Mike
  2. Johnny_Law

    C32 Bad Phono Channel - Can't Figure Out Edit: Figured it out

    My C32's phono is dead in the right channel, and I've isolated the issue to the input switching board. Here are the measurements (this is the Right channel phono section of the input switching board 045-023). I'm stumped and looking forward to figuring this out. -All transistors were pulled...
  3. Traverso

    Power supply Relay replacement for C32 preamp

    Hello, I am looking for relay replacement for the C32 preamp. power supply. Can't find any reference, to be noted my C32 is 220 Volts operated. Thanks a lot for the feedback Cheers Alain
  4. mozcho

    MC7200+C34V or MC2205+C32

    I am helping my friend to get his first Mac setup, there are these two combos for sale from two different sellers. If we just put prices aside, how different will these two sets be?
  5. E

    McIntosh C32 Knobs

    Hello everyone, I'm looking for C32 knobs but I have no luck. Do you know a source of these knobs? Thanks in advance.
  6. Johnny_Law

    C32 Component List?

    I am looking for a simple list of transistors and electrolytic capacitors for each of the boards in a C32. If someone has such a list, ideally grouped by board and mapping component identities to values (e.g., Left Input Switching, C201 = 3.3uF / 25V, and so on), that would be fantastic. I...
  7. sabrefencer

    C32 Left channel level drops significantly when Eq is engaged

    I was evaluating a C32 for purchase and it was fine with the Eq defeated. When eq was engaged, the left channel volume went way down. Any ideas? Could it be the ribbon cables? Anyone had any experience with the aftermarket cables sold on Ebay?
  8. Johnny_Law

    Help! How to make bulb-backlit same brightness as newer gear?

    Proud new owner of a C32 pre-amp - which I'm using with my MC7300 - both thanks to huge generosity of AK members. I love how they both look, but the C32 is a bit dimmer than the MC7300. I would love any ideas to help get the C32 to brighten up to match the MC7300's brightness levels. Would...
  9. R

    Inherited a vintage McIntosh system, seeking advice.

    Hello, this is my first post here. I’m seeking advice on a McIntosh system that I inherited from a family member. It is the following components: -C32 preamp -MC2300 amplifier -XR7 speakers -MQ102 environmental equalizer The components are all in good condition minus a few issues with the...
Back
Top Bottom