• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

channels

  1. Richs_Trains

    Marantz 1060 un-even channels, any insights?

    I have a Marantz 1060 that I bought not working and tried to rebuild about a year ago. I recapped everything except P-400 and replaced the fried outputs and the filter caps. When I got it, it was a dead short on the dbt and after replacing everything and adjusting the amps using the...
  2. jinjabred

    SA-9100 Extremely output

    Hello, I am an amateur electronics technician. I'm having a problem with my loved SA-9100. I recently had transistor Q4 of Power Supply Circuit B puke it's guts up. I was pouring a glass of Dr Pepper as the needle dropped and I'm suprised it didn't end up all over the floor. So I replaced...
  3. R

    Balancing Left & Right Channels On Turntables

    I have the ATLP120USB. Whenever I record songs to Audacity (the software packaged with my turntable) the right channel was clearly not recording as high as the left channel. I was initially using the balance control on the software to fix it. But I found out something that made a night and day...
    • rdkemp13
    • Thread
    • atlp120 audacity balance balancing channels left right shim tracking vertical tracking angle
    • Replies: 2
    • Forum: DIY
  4. Raphaz

    Wiring three pairs of speakers

    I try to figure out if the following can be done, and what the best way is to do it: Current setup: - Large open loft space, high ceiling - 150 W PC amp – selectable A, B, C and AB channels (I have the pre/main switched on) - Chanel A: Pair of KEF Q500 @ 8 Ohms & KEF PSW2150 (bi-wired) I'd...
    • Raphaz
    • Thread
    • channels pre/main speaker switch wiring
    • Replies: 51
    • Forum: Speakers
  5. P

    Pioneer, Technics SA-600 problems.

    Hello all, my name is Will. I'm not sure of the rules around these forums. I'm not even sure if I'm posting this in the correct spot. I hope that the moderators would move my topic if it's listed incorrectly. I've got some problems with one of my vintage receivers. I'm inclined to learn...
Back
Top Bottom