• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

current

  1. zastin17

    Sansui and Their Mis-worded Service Manuals. AU-666

    Here is the Sansui Au666 Current Adjustment Instructions. And I am not making sense of their wording. It says to put the Meter in place of "F003", but also to point 27"which I believe is filter block, and Point B1,and B2. But I can't do both at the same time right? Also point "27" only exists...
  2. D

    Ok, Does this Dynaco MK 3 work with Wilson Audio Watt 3 / Puppy 2 ?

    First off thank you to everyone for helping a newbie many times, this site is amazing! I am looking for a high current tube amp or integrated for my Wilson Audio Watt 3 / Puppy 2's. Under $2K and thinking about pulling the trigger on a set of Dynaco MK 3's at 60 WPC. I have no idea if the...
  3. MAVRICK

    High Current/Low Budget - Big Speakers/Little Understanding

    I'm still trying to learn about this high end audio stuff. So, at the risk of sounding dumb... It's been strongly emphasized that I will need "high current" amplifier/s to drive my speakers (Infinity RS 4.5's). My speaker manual states that I need a minimum of 100 watts, or if bi-amped, 75...
  4. JayPare

    NAD 7060 for 4 ohms KEF Speakers

    I'm looking for an upgrade over my Pioneer SX-737 to drive my KEF Reference Series 101/2 and I came across a NAD 7060. Can anybody confirm me that it can output enough current to drive my speakers? From the 101/2 specs: Amplifier requirements: 50-150W (into 4 ohms) Thanks in advance! :)
    • JayPare
    • Thread
    • 4 ohms current kef kef 101.2 nad pioneer
    • Replies: 4
    • Forum: Solid State
  5. Homer4beer

    Idling current adjustment help - Marantz PM7200

    Hi guys, I managed to fix this amp and am now trying to adjust the bias. I am measuring the voltage across the two legs as per the service manual. I've attempted to adjust the bias now. For the bias for AB, set from cold, I can set both variable resistors to measure 0.4mV < 1 min. For the...
  6. Zak

    Testing Transformers

    Hello all i do apologize if this has been asked already but i am just having a hard time finding good information on the process taken to find the full current capabilities of an unknown A/C transformer. I have tons of transformers i have salvaged, i am sure everyone does, and i would like to...
    • Zak
    • Thread
    • current diy salveged transformers transformer testing
    • Replies: 2
    • Forum: DIY
  7. Richs_Trains

    1090 Basket Case

    Okay, so I bought a 1090 on craigslist for $50.00 to use for parts for a 1090 that I recapped. This unit was filthy inside and someone had pulled 1 output transistor from each channel, a 588 on one side and a 618 on the other. I was just going to take the cosmetic parts I need and trash the...
  8. G

    Newish Rock Music

    Just came upon this video and was playing it on the full 2-channel setup. Bass sounds amazing. I don't know why folks say there's no good rock music anymore.
Back
Top Bottom