• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

d150a

  1. ktm-don

    Line level matching: consumer device driving a Crown D150A

    I'm adding a recently purchased Crown D150A into my home system. It does not deliver the sound level that I expect when driven by my computer sound card or a Bluetooth to RCA box. I researched the topic a little, and of course Crown specifies exactly what it expects on the input. The manual...
  2. Johnny_Law

    Crown D150A - Puzzled. Fixed itself, then distortion came back. DC offset.

    **Edit 7/17/21: Skip to Post #51** **Edit 12/27/20: Now seeing +800mV on Ch.2 output via DBT; Ch.1 is OK** All original transistors and diodes, new electrolytic capacitors. I'm seeing some negative DC offset on one channel, and my outputs from the op amp do not match the schematic. Various...
  3. Johnny_Law

    2N3585 Replacement - Trust NTE? Or pay a ton

    DigiKey has NTE 2N3585 for $15/5 pack (here; datasheet). Mouser has Microchip 2N3585 for $31/each (here) or Central Semi for $12/each (here). Newark doesn't have any. Would you get either of the above, or find a suitable substitute NPN TO66 2A / 300V driver instead? If so ... what? I can't...
  4. terminalVolt

    LF Transducers & Crown D150a

    Hello all, long story short I am needing a way to properly produce 16hz, most woofers simply don't seem to be able to respond at that low a frequency. I plan to purchase a low frequency transducer and either mount it to a stud in my house or to the raised floor and power it off of a d150a II...
    • terminalVolt
    • Thread
    • crown d150a low frequency ohms peak power amp rms transducer wattage
    • Replies: 19
    • Forum: Introductions
Back
Top Bottom