• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

mx110

  1. J

    MX110 hum (continued)

    Hi! Need some advice regarding my MX110 (s/n 591Z9), which was fully recapped in 2013 and partially last year with a transformer replacement. Last year, I had the unit serviced by a local McIntosh service center to fix a loud hum, wherein they added a 10 uF/450 capacitor (I assumed at the time...
  2. K

    MX110 Transformer: source for rebuild

    I’ve run into a McIntosh MX110 with a failed secondary on the transformer. One half of the high voltage secondary measures 40 Ohms and the other half is open circuit (high voltage secondary is the red taps). Audible symptom is that the unit has a hum. I observe a 60Hz ripple on the high...
  3. B

    McIntosh mx110 bottom plate part

    Hello, I have an mx110 but the bottom mounting plate is missing. I have looked on the internet but I can’t seem to find one anywhere. I was hoping someone in the community would have any ideas on where to find one. thanks, Blake
  4. M

    Replace MX110 and pair a modern preamp with an MC240?

    Hi all, Am I crazy to think about replacing/augmenting my MX110 in my system? I have an older MX110 M series unit paired with an MC240. Both units have been restored by Audio Classics. The remainder of my system is comprised of: Klipsch Forte III speakers, Sonos connect, and a Rega Planar 6...
  5. jaaronb

    Restored MX-110z - one channel out on phono only

    Hey folks - first and foremost, thanks to the wealth of information y’all have posted on here over the years, I’ve been enjoying the fire out of a really nice condition MX110z I picked up a few months ago. Short story is, I’ve got a nice MX-110z I’ve been rebuilding a step at a time over the...
  6. Alfmonster

    McIntosh MX110Z and C20 (later model)

    Hi, I've been wanting to get a tube preamp for quite some time and am now able to go either way between an MX110Z or a c20. Both have been looked over and meets or exceeds original specs. Perhaps what is causing a pause from going with the mx110z is the cosmetics. The gold lettering is...
  7. Elemental

    Biasing Question on Mx110 Preamp Section

    Technical question: I'm troubleshooting distortion on a McIntosh Mx110Z and wanted to rule out incorrect biasing of the 12AX7 tube (V15) which is the first stage of the preamplifier section. Looking over the schematic, something doesn't make sense. The schematic says that on, say, the right...
  8. DrRobocop

    MX110 Right Channel Out

    Hello all, Long time lurker, first time poster. I'm seeking some guidance regarding my MX110's non functioning right channel. Thanks to all helpful contributors and wonderful info on this site, I took it upon myself to repair my newly acquired MX110 after a local tech made a real mess of...
  9. J

    No sound out of MX110 tuner

    So my MX110 is now recapped (basic recapping) and have no more smoke on 220ohm resistor (R152) (other thread). Now, there is no sound coming out of the tuner - not even noise - switched in/out the muting switch. nothing. There is a slight movement in the tuning visual indicator when I roll...
  10. J

    MX110 - Smoke on 220ohm resistor after recapping

    Hi, Bought a MX110 3 weeks ago - I never turned it on - and I just finish recapping it. I first started it with a Dim Bulb Tester and everyhting was working fine. Then went without. One of the 220ohm white resistor near the electric plugs started smoking (Pretty sure it is R152 - it is...
  11. fairchild,mcintosh, and klipsch

    fairchild,mcintosh, and klipsch

    my latest listening setup. klipsch hersy'II's fairchild 260 amps mcintosh mx110 tascam cdrw-4u
Back
Top Bottom