• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

tube matching

  1. Walter R

    Tube Matching - TV-7 vs Plate Current

    There are two methods commonly used to perform tube matching, using a tube tester or by measuring in-circuit plate current. The tube tester would seem preferable, but my TV-7 measures transconductance at a plate voltage of 150 vdc while the in-circuit plate voltage is nominally 440 vdc. So I...
  2. Walter R

    Tube Matching Question

    I just bought a tube socket adapter to measure the zero signal plate current in the two 6L6s in push-pull operation in each of my two HF-20 amplifiers. The venerable RCA tube manual says the typical zero signal plate current is 116mA for a Class AB1 amplifier in push-pull operation at 450v...
  3. klamsoss

    X-100-B tube matching help needed

    I'll do a full write up this summer when my resto-mods are complete, but I need some help to get there. A trusted tech in TX made my unit functional. The work was just fine, and I have really enjoyed the few hundred hours of listening, so far. So much so that I'm ready to take it to the next...
  4. Salbreth1

    Tube checker recommendation... Again

    So I'm looking for a checker that will do a variety of tubes as well as output matching. I'm fairly new to the tube world but from what iv read Hickok is one of the go to brands. I have a $600 budget and am looking at a calibrated 752A and an 800. Both are transconductance models. The first...
Back
Top Bottom