• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

x100b

  1. Johnny_Law

    Fisher X100B Distortion?

    My Fisher X100B has been serving daily duty for a little over a year and has sounded awesome (after all it is a former @rufleruf unit, it already received a recap and a replacement OPT as noted here...
    • Johnny_Law
    • Thread
    • distortion fisher x100b
    • Replies: 5
    • Forum: Fisher
  2. klamsoss

    X-100-B tube matching help needed

    I'll do a full write up this summer when my resto-mods are complete, but I need some help to get there. A trusted tech in TX made my unit functional. The work was just fine, and I have really enjoyed the few hundred hours of listening, so far. So much so that I'm ready to take it to the next...
    • klamsoss
    • Thread
    • fisher tube matching x-100-b x100b
    • Replies: 15
    • Forum: Fisher
  3. Ronito6

    PCB Fabricator - opinion and suggestion request

    Here is the second generation F-2772 phono motherboard for the Sansui X1. Using DipTrace, I sightly modified the trace paths to accept the contemporary small signal relay Omron G5V. Basically I'm hoping someone can suggest a PCB fabricator. A North America based maker is first choice, but...
    • Ronito6
    • Thread
    • board makers pcb pcb fabrication pcb maker sansui sansui x1 x100b x11
    • Replies: 21
    • Forum: Exclusively Sansui
  4. L

    need advice on x100b

    i picked up a x100b a few weeks back and have started going through it. i installed a new quad of eh 7868's along with two new sovteks 12ax7lps, set the bias at 40v. per the service manual & checked the voltages. all the voltages seem a little high. line 122vac outputs 457vdc at the plate & 405...
    • ludite
    • Thread
    • x100b
    • Replies: 13
    • Forum: Fisher
Back
Top Bottom