• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Lets see all them Amplifiers!

Traynor YSR-1

I spent a couple of hours yesterday trying to heal mine, with some success. Reverb was cutting out and/or noisy, and scratchy noises in input 2 without input signal. I replaced the three preamp/tone 12AX7s (V1, V2 and V3) and replaced the signal wire from the chassis RCA jack where the reverb output comes back in and the problems appear to be in remission! Sounded great last night.

There is a second wire leading from that chassis jack. It runs to the reverb footswitch jack on the back panel, and I don't fully trust either that wire or jack, so I may need to pull it back open and replace or re-solder those things, too. However, the footswitch was working last night and the reverb buzzing was gone. So far, so good.

Otto
 
Traynor YSR-1

BTW, do you have any issues with getting shocked by that amp?

Mine was wired per the original spec with the dreaded "ground" switch and so on and I was getting shocked in the studio all the time.

I pulled it apart and rewired the power connection per modern standards with a three-wire plug, proper ground to chassis, hot lead first to inside lead on fuse holder, removed the "ground" switch entirely, etc. and have had absolutely no issues ever since.

Otto
 
then there is this one.


130586370.jpg


130408564.jpg



Love the stuff that comes from Stevensville :thmbsp:
 
Love the stuff that comes from Stevensville :thmbsp:

Yeah I lived about 10 miles from the factory when I got those, A Recording Amp, Doug Sewall and Mike Clark dialed the amp in with my tubes Mullard EC81's and an EC83 for the verb and Nos Seimens EL34's for power. They also built the Cab one off with a V30 and G12H instead of 2 V30's and put the matching grill cloth on instead of black to match the head.

Once it was done that had to go get Paul to check it out. They are big on service in the AMP Dept.
 
Hughes & Kettner tubemeister 36:D
 

Attachments

  • critters 030.jpg
    critters 030.jpg
    39.3 KB · Views: 13
  • critters 021.jpg
    critters 021.jpg
    97.1 KB · Views: 20
Oh my.... I'm in love!!

I've wanted to check one of these out since they came out.

Very nice!
Thanks. And before you think I have this much money to spend on guitar gear, I got the half-stack for less than half of what they cost new, with only six months of occasional use on it. Yes, it sounds brilliant, it's bloody versatile, and it sounds better than every amp it's capable of imitating. By all means, if you can find one, snatch it up.

I built the guitar myself, by the way.
 
Thanks. And before you think I have this much money to spend on guitar gear, I got the half-stack for less than half of what they cost new, with only six months of occasional use on it. Yes, it sounds brilliant, it's bloody versatile, and it sounds better than every amp it's capable of imitating. By all means, if you can find one, snatch it up.

I built the guitar myself, by the way.


Same here. I have a Framus Dragon, and the only reason I could afford it was because I knew the assistant manager at GC, and I got it at the price they paid for it. Same thing with my VHT (Fryette) cab.
 
My decidedly humble setup of Gibson Lab5 (and Peavey Predator). Now if only I could play the guitar...

attachment.php
 
Last edited:
I don't have a picture of just the amp on my computer but you can see my Peavey Classic 50 410 in this pic.
Very versatile and underated amp and the best thing is I picked it up for $375 :thmbsp:

Mark

 
Built myself a little 9v practice amp. Sounds just loud and nasty enough to annoy my wife.



Nice!
I've built a couple of those myself. Did you go with a already populated board or build from the ground up? I've been taking the easy route and getting mine from Guitar Fuel ;)

RC
 
Nice!
I've built a couple of those myself. Did you go with a already populated board or build from the ground up? I've been taking the easy route and getting mine from Guitar Fuel ;)

RC

In the past i've used little diy kits where you get all the components and solder them onto the pcb. This time i was lazy and bought a 'Kemo' 3.5watt amp module and wired it up with a switch and led.
 
DSCN0246-2.jpg
[/URL][/IMG]

'92 Kendrick reverb tank, '55 Deluxe, '67 Deluxe Reverb, '62 Pro, '65 Vibrochamp, '65(?) Princeton Reverb, '65 Vibrolux Reverb.

Every one of these amps has worked for a living.
 
Back
Top Bottom