Might help is you listed the drivers.Since I have a couple of large drivers, which of these configs is recommended? Any preferences? I was thinking about slot subs driving down.....or just pointing them down....
Kevin
I use a little treatment like that behind my ESS AMT 1B's. Makes a very noticeable difference. Really clears up the upper mids and highs.Continued to tool around the internet and this thread and realized I had a hard (brick) wall right behind my test setupView attachment 1723295 . Thanks to my dearly departed grandmother the previously mentioned shrillness is almost all gone. Apparently crocheting saves ears. And the experimenting continues...

Didn't waste any time did ya'.![]()
Very nice. The addition of OB woofers to the BG17's would be a huge upgrade. You could even add a single stand alone Eminence Alpha to what you already have.
View attachment 1727826
Hey Poultry,
I always value your advice and opinions. Can you take a look at this single 10inch driver and tell me how special it is?
https://www.cubeaudio.eu/cube-audio-f10-neo
Edited because I forgot to state the drivers I was am fond of!!!!!!!! The Lii Audio Fast-10
I've only had this driver for a couple days and they have barely had a few hours on them but I am sweetly impressed with them. They do seem a tad shrill when driven loud, but I'm hoping that might calm down after a while. They are pictured here on a very crudely slapped together 3/4' MDF baffle but I actually think they might end up in a cabinet of some sort. I heard them in the curvy cabinets shown on the Lii website and they sounded glorious. I also heard them on Steve Deckert's Reference Series baffles and they were again splendid. In comparison to the other wide range drivers, I think I have to give them the nod. They are being compared to the Fostex 206E, Coral Holey Basket, Altec 755c, AudioNirvana 15" cast ferrite, EV 12TRXB, and some others of mention. I don't think they lack too much on top, but I have a pair of Great Heils to experiment with once I decide on how to treat the drivers. One thing is for sure though, they are nice![]()
Edited because I forgot to state the drivers I was am fond of!!!!!!!! The Lii Audio Fast-10
I've only had this driver for a couple days and they have barely had a few hours on them but I am sweetly impressed with them. They do seem a tad shrill when driven loud, but I'm hoping that might calm down after a while. They are pictured here on a very crudely slapped together 3/4' MDF baffle but I actually think they might end up in a cabinet of some sort. I heard them in the curvy cabinets shown on the Lii website and they sounded glorious. I also heard them on Steve Deckert's Reference Series baffles and they were again splendid. In comparison to the other wide range drivers, I think I have to give them the nod. They are being compared to the Fostex 206E, Coral Holey Basket, Altec 755c, AudioNirvana 15" cast ferrite, EV 12TRXB, and some others of mention. I don't think they lack too much on top, but I have a pair of Great Heils to experiment with once I decide on how to treat the drivers. One thing is for sure though, they are nice![]()
No, neither myself nor @Nixxuz have needed it. We're both running the same drivers.
I agree with mjw21a. While the Fast10 don't cover quite enough of the frequency spectrum, by themselves, what they do cover seems spot on to my ears. Reading over at DIYaudio.com, I'm seeing that, much like the Coral drivers they resemble, the Fast10's have those "rings" on the cone for rigidity, allowing them to have a surprisingly low mass. Or something like that. I'm no expert on T/S parameters. If I had a full on shop, and the time, I might try then in a TL design. Or maybe in the cabinets made for the Crystal10's.Might the Fast-10 require a corrective circuit? Not uncommon for full range drivers to have a wart or two.