Polk m 10a
- Thread starter Rixter74
- Start date
Register to hide this ad
Dswankey
Lunatic Member
Yes especially if they have magnet issues. What do you mean by "should I do all the speakers"?
RTally
Speaker addict
Where are you located and what is your market like? The value of the speakers depends on where you are and what your market is like.
I have a pair of Monitor 10A speakers. I paid less than half of that, but I need to repair one driver. Mine came with the nice Peerless tweeters. As far as perfect condition, these speakers have vinyl covered cabinets. Generally, there are only two conditions for the vinyl: trashed or good condition, so "perfect" does not require much of a premium.
And yes, every mid-driver should have the magnet epoxied in place if not already done.
I have a pair of Monitor 10A speakers. I paid less than half of that, but I need to repair one driver. Mine came with the nice Peerless tweeters. As far as perfect condition, these speakers have vinyl covered cabinets. Generally, there are only two conditions for the vinyl: trashed or good condition, so "perfect" does not require much of a premium.
And yes, every mid-driver should have the magnet epoxied in place if not already done.
MonkeyRelish
Active Member
Use Loctite power grab on the mid woofers only. One bead above and one below the magnet. The woofers are passive, so no magnets. Depending on the model tweeters installed, POLK make a better sounding replacement. Jump on the POLK forum, plenty of good info.
Mr Relish
Rixter74
New Member
Thanks everyone. Around here limited amount of good equipment. Aas far as perfect. I meant one owner very well taken care of. A pair of cerwin vega ls 12s went for 200 in 20 minutes yestarday. This guy is holding for me till today. Im going to go get em. Should have said all the magnets?
