Hello! I recently came into possession of some cool (I think anyway) audio equipment. It all belonged to my grandmother so I want to keep it and use it.
I have a
Marantz 6300 turntable
Marantz 5220 cassette deck
Arvin 75P88 complete cabinet with turntable and speakers circa 1965 I think...
I'm refinishing the plinth on my 6300 and I can't for the life of me figure out how to remove the strobe cover. I've read pull up, rotate 90 degrees, but I'm terrified of cracking the cover. Anyone know how to safely get the thing off? Thanks!
So my buddy called me yesterday and said he seen his neighbor throwing out some giant speakers and a "Big silver radio thing" and asked if I might want it. I told him I had enough problems but to go ahead and grab it and I'd come check it out. Worse case scenario I'd have some switches and stuff...
Hey folks! First post! I’ve got a wonderfully restored Marantz 6300 (thanks to restoration sound in NC) paired with a 1060 amp and playing through Sansui SPX-9000 speakers. Recently, I picked up an extra head shell that came with a really clean Grado G2 cartridge sans stylus. Any...
Hello,
I bought this TT 3-4 years ago and never got around to testing it.
After recapping few amps, I decided to check the 6300 with the hope of restoring the electronics and mechanics, as well as re-veneer the wood.
First thing I did was to turn it on and test the speed and auto stop. The...
I'm recapping the power supply board on my 6300. Also replacing the Diodes and transistors.
There are two diodes (looks like the rectifier) that I can't find any replacement for. They are:
H801 - CO8P2N and H802 - CO8P2R
Can anyone Help with suggestions?
Thanks you
I'm trying to replace the strobe on my 6300 TT but have been unable to pull the bulb out from below. Have removed foot and plate for access. But pulling very hard and cant get it to budge. It move forward ever so slightly but not pulling out the bottom. Also the bulb housing top plate seems to...
Hi group,
I have a 6300 that needs some work.
The cue-ing and auto functions do not work. I am using it in manual.
Who out there does a good job on 6300's? Anybody have some good recommendations?
Thanks for your advice....