Let’s set the scene. A 1970s receiver is on the bench, the lid is off, and somewhere on the main board a tiny black transistor stamped C1345 has quietly given up. That little guy hasn’t been made since disco was still a going concern. Now begins the ritual every restorer knows by heart: forum...
Good morning.
I am rebuilding/repairing a KA-6100 Integrated Amplifier. I have replaced all of the electrolytic caps and verified that they are correctly oriented. When I switch on the power, I immediately blow fuses Fm2 and Fm4. I suspect from reading another thread that one or more of the...
Question regarding Marantz 8b high voltage power supply HV PSU diodes replacement
I am restoring a Marantz 8b amplifier.
It is a straight forward decision to replace the selenium rectifier.
It seems that this would be the opportune time to also replace the high voltage power supply diodes...
Greetings all, I'm starting to post more on AK. It's fantastic that there are so many members that are willing to help newbies like myself. I've replaced all of the caps in the 551 with the exception of the tuner, which I will do once I've finished replacing the transistors (Pre-Power-phono) on...
Thanks in advance for your help. It's great to be part of a community of like-minded individuals.
I've recently recapped an old Hafler DH-500. It's a bit unusual in that it has the pc10a version of the boards which don't quite match the manual available online. Anyhow, I've recapped it and...
Good afternoon AKers!
I've got a 1060 on deck for a rebuild. It hasn't been powered up in a couple years and the glue on the boards has corroded most of the caps pretty well. Nothing has been touched in the power supply since it was manufactured, so it's long overdue for some attention. I've...
hello. I’m sorry for dual posting my introduction and diode request a week or so ago. I’m not trying to cause any extra work on my behalf. I’m sorrry. I did get a whole lot more of a welcome than I ever expected. Thank you guys for that.
Are there any 4H diodes for sale anymore? Im thinking...
Got a "garage sale" SA-6700 today. Fuses blow as soon as the power is turned on. Checked the transformers, as best I could. Doesn't seem to be a dead short in either primary...around 3 ohms resistance. Then I checked the diodes (D21 thru D24) all GP-20D. All of them were open and failed the...
I have a 2220 which I have just started to rebuild. Right off the bat it appears that the P-700 board had a catastrophic incident. (See burn out on R739) I know the 2220 is a low end unit but I want to completely resurrect it as part of my learning. I have removed a few parts and most are...
Been working on a basket case Pioneer A-80 for a while. One amp board and outputs were completely trashed. Replaced the obvious and then tracked down a few more severely out of tolerance resistors. That channel is working just fine and begins clipping at 223wpc using direct mode, 1000hz signal...
I'm in the middle of a Marantz 1122DC restoration and originally noted the amp boards were missing four of the MV-1 varistors listed in the service manual. Once I pulled the board apart I found them on the backside (why?), covered in clear shrink and nasty glue. Looks like they're black and...
Hello folks, getting ready to take my 1200 offline for some maintenance and tuning. Its been on the bench once for relay board caps and diodes back in '09, along with Deoxit and Faderlube, the normal stuff. Now on it's 46th birthday I'd like to do something special.
Catrafter and I spoke and he...