ns-1000m
-
W
Bi-amping the Yamaha NS-1000M Crossover
Hello everyone, I have refinished my Yamaha NS-1000M cabinets and am considering bi-amping the pair...keeping the original passive crossovers. The reason for bi-amping is I wish to use a type 45 tube amplifier for the midrange and high frequencies and a solid state amp for the low end. I would... -
B
NS-1000M woofers
Hi, Just wondering about alignment for the metal plates on the back of the woofer magnets. I added a red arrow in the photo to point at the part of the assembly I’m asking about. They are not centered on the back of the magnets. I’m going to guess they are dust caps for the back of the assembly... -
Yamaha NS-1000M / FX3 Sensitivity
Hello. I have the NS-1000M (90dB) and the FX-3 (92dB). I assume that with the same amp at the same volume settings position of the knob, the volume of the FX-3 should be higher due to higher sensitivity. This doesn't happen with my speakers. The NS-1000M play slightly louder than the FX-3 at...- jmascarenhas
- Thread
- fx-3 ns-1000m yamaha
- Replies: 6
- Forum: Yamaha
-
Sometimes you just get really lucky (Show and tell post)
Have been on the lookout for a pair of ns-1000m for quite a few years now (it just seemed risky to have a pair imported. Traded my kef 105.2 for these, hurts to lose but I think a worth sacrifice Pictures speak for themselves, grills have never been taken out of their boxes. Absolute time... -
F
YAMAHA NS-1000M terminals +
Hi, I inherited a pair of these speakers, and i'm happy to read on these forums that they are worth the trouble i had getting them from Denmark to USA! - My dad got the speakers as a gift from the Danish Yamaha rep back in the late 70's, i believe, so they do have sentimental value to me! I... -
How to 'make' $40 rock solid speaker stands for your Yamaha NS-1000M's (or any speaker)
I was searching quite some time for affordable and solid speaker stands for my NS-1000M's. I needed them to be heavy, solid and good looking. And most of all, they needed to be affordable. So I received several quotes from different companies around the globe, read a lot of DIY threads where...- Mr. Yamaha
- Thread
- diy ns-1000 ns-1000m speaker stands yamaha
- Replies: 8
- Forum: DIY
-
J
NS-1000M speakers - not working correctly upon arrival
Hello, I bought a pair of NS1000M speakers. I discovered one speaker's woofer is damaged and the other speaker only has sound from the midrange speaker. I received over half my money back and plan to repair the speakers. Any ideas on why sound on only the mid range speaker. I can deal with the... -
H
Yamaha NS-1000M binding posts and speaker stands
I finally broke down, and after 36! years of ownership, I have replaced the lame spring speaker terminals with a nice set of banana jack binding posts mounted in 3mm maple plates. I also replaced the 20/22awg bell wire with 14awg from the new posts to the crossover board. Also, a shot of my... -
Yamaha NS-1000M rattling sound
Problem is next: I figured out left speaker produce less bass than right. First I put under investigation my amplifier – Kenwood KA-9100, but after switching speakers between channels I have got same effect - left speaker was out. It is clearly seen when you push 40Hz or 45hz signal from...