• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

Open Baffle Epiphany!

Thank you PG, Yes, it was because of you and Godzilla that I ordered the Beta 12LTA. I had wondered towards the end of this thread what bucket subs are. PG did you build those?

I have a question for anyone. If I have a couple speakers connected in parallel (say the Beta 12LTA and ASD 1001) and I wire a cap in series with the tweeter, how does the cap influence the nominal impedance of that system? In other words, the two 8 ohm drivers in parallel would render a nominal impedance of 4 ohms that the amplifier would see. But, if I add a cap, say 1.0 uF, what would the nominal impedance be? I just wonder if it is a significant amount or not, so I don't feed my SETs too little of a load.
 
Adding a high efficiency tweeter to the 12LTA is not a problem. Your amp won't know the difference.

I built my bucket subs after hearing the inventor's pair as HS Horns is near by. I did add a plywood ring under the baffle so I could use screws rather than gluing the drivers in place. I also used piano black ( :D ) buckets I special ordered from Home Depot. These are true subwoofers and here's the link:

http://www.transcendentsound.com/Subwoofer.html
 
Adding a high efficiency tweeter to the 12LTA is not a problem. Your amp won't know the difference.

I built my bucket subs after hearing the inventor's pair as HS Horns is near by. I did add a plywood ring under the baffle so I could use screws rather than gluing the drivers in place. I also used piano black ( :D ) buckets I special ordered from Home Depot. These are true subwoofers and here's the link:

http://www.transcendentsound.com/Subwoofer.html
Thank you PG, This looks really realy cool!!! I imagine I still would want to build the H-Frame with the 15 Alpha and add this later, not try to be so cheap to try to skip the 15 Alpha H-Frame?
 
Great informative thread. 110 pages and going strong!

My OB's are back from their lengthy hiatus while pulling speaker duty in my studio. I've recently acquired a Rolls SX45 2 way crossover and I will attempt to finally get these things working properly. Hopefully it won't be too difficult getting them dialed in.

I am surprised at just how bright these are running all six drivers wide open. They are bright even compared to my Klipsch CF3s and way more bright than my Sony's are. I should note however that these particular Klipsch are very tame compared to most of their siblings. So the challenge, of course, will be to integrate the Alpha 15s and the Audio Nirvana Super 8s so that I can finally hear these as they are meant to sound.
 
Thank you PG, This looks really realy cool!!! I imagine I still would want to build the H-Frame with the 15 Alpha and add this later, not try to be so cheap to try to skip the 15 Alpha H-Frame?

By all means build the H-frames first. That's really all you need.
 
I think David Dicks' plans call for his AN full range drivers running full range without correction. I noticed a picture of OB's with augmenting woofers recently added to his website.
 
I know you've got the AN's but I can't keep up with what everyone else is using.

This is my favorite part of this open baffle "experiment". It's so easy to swap drivers of different vintage, size, materials, etc. I've tried maybe 6 or 7 different combos already and have spent A LOT less than a pair of box speakers I had previously. These OB have smoked the lot of 'em...

I'm considering swinging for the fences and trying a high end field coil or something way up the ladder from the 50's drivers I'm currently messing with.
 
This is my favorite part of this open baffle "experiment". It's so easy to swap drivers of different vintage, size, materials, etc. I've tried maybe 6 or 7 different combos already and have spent A LOT less than a pair of box speakers I had previously. These OB have smoked the lot of 'em...

I'm considering swinging for the fences and trying a high end field coil or something way up the ladder from the 50's drivers I'm currently messing with.

After living with the Zeniths for 18 months "Mr Glow-in-the Dark" says he sold off his Rullit field coils and Supravox. Never heard field coils but Nelson Pass uses Lowther FC's in his OB's. I lusted after the French Supravox for years but not so much now.

I may try a different tweeter but the Zeniths are staying put above the H-frames. You might look for a good deal on used Lowthers and the DX3 is a popular choice ( David Dick's favorite FWIW ). You read about the infamous Lowther "shout" but with the rolled edge whizzer that was eliminated. Any Lowther made in the last 10 years has the rolled edge.
 
I don't think the active will tame the brightness. I hasn't tamed mine.

Part of the brightness I hear is, of course, due to the very different nature of my speakers. Already today my ears are becoming adjusted to the difference in their sound. The OBs are certainly the most dynamic speaker I own. I'm hoping to free up some time within the next few days to play with the Rolls.
 
I think David Dicks' plans call for his AN full range drivers running full range without correction. I noticed a picture of OB's with augmenting woofers recently added to his website.
He may but mine could use a bit of attenuation when used with a 45 SET. Not so much with a 2a3.
 
I've put together 3 different notch filters. They go on the plus side of the FR speaker. HugeDSC_0007 (1).JPG difference IMO. Really smooth's out the AN 10's.
 
The unit on the right was for Cornwalls and I've modified these so I'm just using the inductor & the 10 ohm resistor. I've since added a .22 uf PIO cap which is what I had on hand.
 
The unit on the right was for Cornwalls and I've modified these so I'm just using the inductor & the 10 ohm resistor. I've since added a .22 uf PIO cap which is what I had on hand.

How do you like those AN drivers? I've been thinking about using them, but I keep hearing mixed reviews. I think a notch filter is a great thing for these full range speakers as many have peaks in the midrange.
 
These Saba green cones have achieved a near cult like following. The alnico magnet structure looks much the same as the Zenith 49CZ8** series.

greencone_2_1000pxw_intro.jpg
 
How do you like those AN drivers? I've been thinking about using them, but I keep hearing mixed reviews. I think a notch filter is a great thing for these full range speakers as many have peaks in the midrange.
They get better with time.The reviews you read are the same ones I read I'm sure. Theres plenty of people out there who have had a measure of success using them. Mine getter better with every tweek. My next filters will be much more sophisticated
 
Back
Top Bottom