Very cool.. any updates on this project? How do you like the Fast10 driver?
I'm sure others are getting sick of mjw21a, and myself, gushing over these damn drivers, but I can't help it. They are, by far, the best drivers I have personally heard. Now, you can take that with a grain of salt, as I haven't really heard a lot of higher end stuff. The last commercially made non-DIY speakers I had were a pair of
https://www.jamo.com/products/c109. Now those were pretty great speakers for the insane discount I got them from Amazon for. Retailed for somewhere between $2500 and $3200 a pair MSRP, but I snagged a pair for $400 shipped. They
were what I imagined my endgame would be. But I went down the DIY route after finding just how much money goes into manufacture and dealer markups. I started with a pair of Dayton PS220-8 and Eminence Alpha 15A's in a flat 24"X48" sheet of MDF. It was, in my opinion, equal to or better, in different ways, to the Jamos. It helps that I have no WAF in my listening room, as the 109's were gorgeous looking, and not bad sounding at all. I modified the design a few times, and figured I was probably close to done until I chanced upon the Lii drivers on various forums.
Anyway, that's getting long winded. The Fast10S is a
great wideband driver. They fall off close to 13khz on the top, but my hearing doesn't go much higher than 14khz, and without looking at my spectrum analyzer I wouldn't even know they weren't good to 20k. They also drop off around 75-100hz on the low end,
when not enclosed. I feel I have to emphasize that, as I bought them specifically for OB use. I knew going in that I would be augmenting them with other drivers.