Reverb hook up question

[vintage 5.0]

I am trying to hook up a Pioneer SR 303 reverb to my Yamaha CR 1020 and I am not sure on it. I could use some help. thanks

 

[dumptruck]

between the pre-out and pre-in is where you want that.

 

[vintage 5.0]

So pre out and pre in what about the Coupler it is the switch between them. It is in the left postion do I move it to the right. Also can I run a sub woofer off the reverb I had it on the pre out. Thanks for your help.

 

[similost]

Most people put them on the tape loop... (tape in and tap out) then use the monitor button... Not sure if the Yamaha has that though.

 

[similost]

You can get the manual for that free here:

http://www.hifiengine.com/manuals/pioneer/sr-303.shtml

 

[dumptruck]

So pre out and pre in what about the Coupler it is the switch between them. It is in the left postion do I move it to the right. Also can I run a sub woofer off the reverb I had it on the pre out. Thanks for your help.

In that case leave everything as it is and use the tape loop like similost says. That will for sure be in the manual.

 

[donberry]

always use the tape loop if possible, besides noise issues, you can also take it out of circuit etc if u do not want to use it.

 

[vintage 5.0]

Thanks for the info. I will have to check again I am not sure on the Yamaha there is a moniter button.