emit

Hello everyone, I'm new to the forum I recently aquired a pair of original working Infinity Quantum 2 speakers. As far as I know, they have never had any crossover work done. Both of the Tweeter X-Over Frequency swithces are completely frozen in the HIGH position. I do not want to force them...

Anyone: how to remove the rear round grille? I remember (not sure, its gray back there) seeing that someone said use knife and pop out? Rather have someone confirm.

Hello All, please I need some advice. I plan to buy the speakers in headline, but acc. to photos, the EMIT membranes are warped (please see photos). Of course I plan to see and listen to them, but it is 400 km from my home so I would like to know some advices before I run for them... Is this...

I want to measure my 3 (respective 4) EMIT drivers. What resistance should each measure? How to wire up a) 3 EMIT (front facing) b) 4 EMIT (3 front, one rear)

I recently picked up an unmatched pair of infinity RSb's in somewhat rough shape, but all of the drivers work. I wanted to document a bit of the process I'm going through, seeing as these speakers are getting harder to find. Information on them seems to be disappearing from the internet too, so...

Hi, I refurbish many of speakers, restored wooden boxes, renewed crosovers, repaired drivers. Few months ago I bought RS6000 and made it for me. Woofers were refoamed, veneer was polished and oiled. Look like new and sound excellent: I use it with my valve amp. It chinese PP on KT88 in...

Hello All, Need some advice; I found a pair of Infinity Qb's at the curb-side store...initial look is they're in pretty good shape, then I tested them with mixed results. I took them apart and discovered they've been WAY overdriven to the point that the plastic controls plate melted inside from...

I just acquired these gorgeous Quantums. One thing that i noticed right away is that they have the later 'Polycone' woofers. I checked immediately that they were Watkins and not a standard 12 inch woofer. Fortunately the first was the case, they are Watkins 902-1180 woofers. They sound real...

I just picked up an old pair of Infinity Qe speakers last night for basically nothing. I was not looking nor do I need more speakers...but I found these at such a low price I couldn't help but go look at them. I had to laugh at the poor little kenwood receiver the guy used to attempt to power...

Picked up these Kappa 8’s yesterday in NJ. Other than needing a Woofer Re-Foam and Polydomes ( which I’m developing a replacement part for) they are in Mint Condition!

Hope I'm posting this in the right place... Picked up some Infinity quantum 3s, sans grills, and sans 12" DVC Watkins woofers, sadly. I've got my eyes on ebay and some local classified spots. They appear hard to come by and very expensive second hand. One site 750$ for 2, which I'm sure theyre...

Hello everyone! Long time no post. If you have the time I beseech the advice of Infinity Gurus everywhere. I have been very fortunate to pick up a pair of Infinity Qb's for a reasonable price locally. Even more fortunately the diaphragms of the EMIT Tweeters have already been replaced! A...

Since my Kappa 9's have a blown Semit, and trying to find one is proving impossible, I was thinking of swapping both out for a pair of Soft Dome's, like the Infinity REF-075tx car audio tweeters. I figure I could easily market the good one to pay for those(I'm not offering it, Mr. Moderator) if...

Can someone tell me if the Emit tweeter in the Qa is the same as the ones in my RSII's? Wondering if getting an inexpensive pair of Qa's would be a good way to get a back-up set of emits.