• The move to the new server is done. There are some software and database maintenance updates in process. This has us passing the hat around to help out. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html

wiring help

  1. S

    Speaker Wiring Help

    I am working on an old RS 193B. I have the amp/tubes everything working and am ready to restore them back into the cabinet, sans the record player which was rusted and is not replaced with a newer one. I just need some help with wiring the speakers/capacitors hooking it all up. The left...
    • SpinningJim
    • Thread
    • rca victor rs-193b speaker advice tubes wiring help wiring speakers
    • Replies: 7
    • Forum: Tube Audio
  2. B

    Rewiring turntable power harness for Magnavox Entertainment center

    I recently purchased a vintage Magnavox cabinet—all original—the radio works great, but the last owner took out the turntable and dropped a new one in (and connected it to the FM/MX channel). It's a basic one—that's literally the name of it. I started tinkering inside and found the turntable...
    • bvinson
    • Thread
    • magnavox turntable wiring help wiring issues
    • Replies: 4
    • Forum: DIY
  3. S

    Tip-Top Audio 8175 & 8127 Headphones Wiring Issue - Help Needed

    Hi Everyone, I recently acquired 2 pairs of vintage headphones made by Tip-Top Audio. They're cosmetically in perfect condition minus the swapped out cable on the 8127 and the replacement mesh inside the 8175. They're great for decoration, but I bought them with the hopes that I can fix them...
    • smonkulf
    • Thread
    • headphones tip-top vintage headphones wiring diagram wiring help wiring issues
    • Replies: 2
    • Forum: Headphones
  4. L

    Cambridge SoundWorks 2.1 Help

    Greetings from Nebraska, I recently picked up this set of speakers from a Goodwill for $10. I didn't know anything about them, but the included carrying case with cables caught my eye. The label on the subwoofer unit reads - "SoundWorks by Henry Kloss, copyright 1996 Cambridge SoundWorks...
    • _Luke_
    • Thread
    • audio question cambridge soundworks power supply board soundworks wiring help
    • Replies: 4
    • Forum: Speakers
  5. L

    Realistic Lab 400 pot wiring

    I picked up a Lab 400 this summer for 10$. When I got the speed was inconsistent and would spin sometimes or not at all. I cleaned the pots and it seemed to get better. I decided to clean the speed adjusters on the motor. I think I got carried away and after that it wouldn’t work at all or if...
    • locodrvr
    • Thread
    • potentiometer realistic lab 400 wiring help
    • Replies: 0
    • Forum: Turntables
  6. Wolfwood

    My ceiling speakers have 4 binding posts. (RIN) (LIN) How to wire them ?

    Howdy AK. It's been a while. Too long :) I recently purchased x10 of these in-ceiling speakers for install in my brother's place. ( MM 650d ) Elan in-ceiling speakers. There is very little installation instruction online regarding these units. ( Plenty of instruction on mounting them but not...
    • Wolfwood
    • Thread
    • ceiling speakers diy in wall speakers speakers wiring wiring help
    • Replies: 10
    • Forum: DIY
  7. O

    Rewiring An Astatic G Stand With A 3 Pin Connector

    I have an 3 pin Astatic G stand that I wish to add a 3 pin female connector to the end of the cord. The cord has two white wire conductors with shield. Which wires do I solder to pins 1 - 2 - 3 on the connector shown? White wire with orange terminal dot to pin number ? White plain wire to...
    • ookpik
    • Thread
    • 3 pin astatic connector connectore wire color microphone repair wiring wiring help
    • Replies: 3
    • Forum: General Audio Discussion
  8. N

    Delmonico Model 1025 Console wiring question

    I'm repairing this vintage phonograph/radio console, just needed new rectifier tubes, now reassembling. There's a green/black ground wire coming from the turntable (cartridge I assume) and I can't remember where it attaches. This unit has a hot chassis so I want to be sure. Thanks for any help!
  9. Houston

    Complete Altec Setup - Help Please

    I ran across a complete Vintage Altec setup. I replaced the horn diaphragm, ohm’d the sub, and powered up the amp to ensure it’s operational. I Wired in a RCA female, 120 volt switched fan, built a housing for the horn to be closed in, then fixed cosmetics to existing box. The horn sounds great...
  10. H

    Wiring to amp question Heath Kit As-103

    I was given a pair of As-103 speakers that needed a bunch of work done, I have gotten the work done on them and they look original and are functional. However I gifted them to my Dad and they seem to be very quiet. With the money spent at the professional speaker repair I want to ensure they are...
    • HeathCat
    • Thread
    • as-103 heath kit wiring help
    • Replies: 5
    • Forum: Speakers
Back
Top Bottom