I might be in love

[Montycat]

That SOTA Reflex clamp is a good one. The collet chuck, in the centre, is adjustable. There is a hex screw that you access from the bottom, which allows you to drop the chuck, a bit, so that it sits flush, when clamped. Unless the spindle is tapered early, or the chuck jaws badly worn, you should be able to adjust the clamp so that it gets good purchase, with the right amount of clamping pressure. If the jaws are worn, I would call SOTA to see if replacements are available. I have the I-clamp, and I love it.

Yes, I've tried to adjust it but it appears either stuck or perhaps bottomed out. The jaws seem ok and the screw inside them is a flathead screwdriver type. I think the real issue is the lever cam. The aluminum part that pushes on the end of the steel screw seems worn. That part might need to be replaced.

I think I'll try to take it apart and will contact Sota.

 

[Bubbalouie]

I've installed my Linn Asak cartridge on it with an old Micro Seiki headshell. It seems to work pretty well.

I'm thinking (always thinking) that veneer on this plinth would be nice. Has anyone ever attempted that over the rubber SH-15B3? The B2 is so much prettier, plus this one has some cosmetic flaws. It's not that bad by any means but there are a few scuffs and places where the mounting screws from underneath seem to have been created bumps in the top from being screwed into too far. At least that is what it looks like.

I have to look around for an arm lifter too. I could steal one from an old Sansui arm I have but might pick up a Jelco or something.

Mose Allison - Mose Goes by Buhduh, on Flickr

This is what you need Monty. You can find them on FleaBay, the ad ended on this one. They show up quite often. Congrats on your "new" turntable. If you should ever get tired of it...