• Check out the Annual AK Secret Santa exchange Program, signup before November 23rd in the AK Charities & Christmas forum!

sa-8800

  1. E

    Low hum 50Hz in both channels SA-9800, SA-8800, SA-7800

    Hi all, I do have all three models of Pioneer amplifier (SA-7800, SA-8800, SA-9800) in everyday use. I bought them over the last 12 years and must have repaired the units with the help of Audiokarma forum (specifically thanks to Markthefixer). They all run fine, however I can find very little...
  2. Bob123456

    Pioneer SA-8800 - high voltage readings

    Hello, newbie here hoping for some advice. I was recently given an SA-8800 in not-great-condition to refurb and sell on behalf of an elderly relative. I've got a little experience with electrical repairs and I guess I've had some luck in the past, but I have limited equipment (and space) to work...
  3. MAG_1944

    SA-8800 Hum problem

    Hi Everyone I've recently begun to use a pair of headphones with my amp for late night listening, I've noticed a low level hum which doesn't seem to change with volume. Checks I've done so far, checking between all 4 inputs, no change. Toggling loudness, muting, tone, high and low filters, no...
  4. alexhastings

    SA-8800 protection mode help

    Hi! I'm trying to get my SA-8800 working - it's stuck in protection mode and I'm at a loss. I've replaced all the components on the GWH-128 board that are marked with a /!\ on the schematic (been meaning to do that amnyways - when this amp was working it had issues with the L channel cutting...
  5. QSilver

    SA-8800 Phono stage problems

    When I connect the SA-8800 up to my turntable it plays just fine, until you want to crank up the volume. If the volume gets past the 1W mark, sometimes the 10W mark, I suddenly get a massive resonant hum. I haven't checked but it sounds like it would be around the 100-200Hz area. Reducing the...
  6. QSilver

    SA-8800 Oscillation?

    Went to switch it on today and it took longer than usual to come out of protection. Then I heard a slight crackling noise from inside the amp. Turned it off, and smoke came out from the front right corner of the amp. Damn. So I took it to the bench. R80 had burned up. I changed it and replaced...
  7. whitecastle

    SA-8800 Recap & Power Questions

    Hey folks. Just had a couple questions before I consider a recap of my SA-8800. I was looking over the recap list for this amp here. I noticed it does not list replacements for the 4 x 12k 63V Caps mounted on the PA assembly (AWR-182). In p18 of the service manual, these are shown below the...
  8. QSilver

    SA-8800 no right channel on power up.

    I've been going through doing a recap of this beast which has gone well - as well as replacing a number of resistors that were looking past their best... Before the re-cap and after, I have noticed that on first powering the amp on, the left channel works fine but the right channel isn't there...
  9. QSilver

    SA-8800 Capacitor drain

    I'm working on one of these at the moment - giving it a recap and changing some of the resistors that looked a little stressed. I discovered yesterday while working on it (having left it switched off and unplugged on the bench for two days) that the negative main reserve caps still had -45VDC in...
  10. QSilver

    Pioneer SA-8800. Keeping the display going.

    I managed to pick one of these up this week. Cannot believe my luck! After a good clean its gone from dull and tired to an almost mirror shine with an amazing sound too! :music: I'm thinking of going through and giving it a recap, as well as replacing a lot of the important resistors that are...
  11. Gary D Olson

    SA-8800 Refurb Starting In 3, 2...

    Greetings Pioneer lovers. My main amplification in rotation these days comes via Luxman R-117, Yamaha C70/M70, Marantz 2330B, and a Pioneer SX-1250 on indefinite loan from a client. Several months back, I purchased an SA-8800 off ebay without its top cover for $200. After a thorough controls...
  12. K

    Pioneer SA-8800

    Hi there I'm trying to find a metal top cover for my SA-8800. Does the SA-8800 share the same cover with other models? Thanks Thomas
Back
Top Bottom