yamaha
-
Yamaha CA-1000 pilot lamp
I need confirmation that my Yamaha CA-1000 pilot lamp is for sure a 12v 60ma bulb. Would any 12v bulb work? Or a 12v LED instead? Thanks in advance!! -
Yamaha CR-800 meter lamps wont work.
I recently picked up a super clean CR-800 and of course all of the lamps were out. I got some LEDs on ebay and started swapping them out. When I turned the power on, the dial indicator lamp worked, but all 3 of the meter lamps did not. I can't get any power reading at the meter lamp lugs... -
Yamaha CR-640 Component Identification
Hello, picked this unit up today and pulled the cover off to have a look. There are 2 square tubes protruding up from the board. One is loose and the 2nd one is not. They both seem to have corrosion around them. The loose one is circled in red in the attached picture. What is the function of... -
Yamaha K-550/560 Service Manual
Hello group, Does anyone of you have a service manual for the Yamaha K-560 cassette player? It is not available anywhere.... There are only two ads (paid, of course). I will be grateful, it will make my work much easier. Yours faithfully. David- Dawid Ratal
- Thread
- yamaha yamaha k-560
- Replies: 1
- Forum: Yamaha
-
Yamaha RX-V685 Entering Protect Mode: Need Troubleshooting Help
Hello everyone, I've run into an issue with my Yamaha RX-V685 receiver. It's about 3 years old and has recently entered protect mode with the error "DC PRT: 255". When I turn it on, it shuts off within about 3 seconds. I'm comfortable with electronics, have a multimeter, esr tester, just have... -
CR-220 Burnt Resistor
Hi All, I opened up this Yamaha last night that I purchased broken, it has what sound like a 60Hz hum and It looks like the culprit is this burnt section here, the only trouble is that the resistor thats burned out in my photo doesn't seem to exist on this diagram, its simply marked with an "r"...- HotRodStereo
- Thread
- cr-220 yamaha
- Replies: 16
- Forum: Yamaha
-
J
Is it bad to turn off the external pre-outed amplifier for front L/R speakers to only have Rear Stereo on my receiver?
As the title says, I have a Yamaha RX-A4A receiver that pre-outs the Front L/R to an external Yamaha A-S1100 stereo integrated amp. I have the KEF R11’s as front on the external amp, and KEF R2C + KEF R3’s as center and surround speakers respectively (no subwoofer anywhere, for now). My...- Joris Ceoen
- Thread
- a-s1100 rear stereo only rx-a4a turn off external amp yamaha
- Replies: 1
- Forum: Solid State
-
M
Yamaha CR-1020 Case Measurements
Hey folks, I was just wondering if one of your number could do me a favour and measure their original Yamaha CR-1020 case from the front edge that butts up against the faceplate to the front edge of the top grill? I have my receiver out for reconditioning a few hours away and forgot to take... -
H
Yamaha CR1020 lights have stopped lighting up on the three meters
Hi everyone. CR1020 continues to work beautifully after service and recap but the three light on the meter displays have recently stopped lighting up - I think simultaneously - although they had been working just fine. So where should I look first? Easy to say "replace the bulbs" but the fact...- Hifibythekg
- Thread
- bulbs cr1020 meter yamaha
- Replies: 8
- Forum: Yamaha
-
Yamaha CA-1000 Front Panel Potentiometers replacements?
I am looking for information on possible substitutes for the Bass, Treble, Loudness potentiometers. The Bass & Treble appear to be logarithmic with a center detent. Correct? They are also Dual Shaft which is a lost Art, with no possible new replacements. Correct? The Loudness appears to be a...- Yamaha5000
- Thread
- potentiometer yamaha yamaha ca-1000
- Replies: 10
- Forum: Yamaha
-
MX-1000 stopped working after I cleaned it!
(posted on another thread but reposting it here - thanks @avionic!). Hi All! I'm another newbie audiophile who's got a MX1000 on the fritz (picked it up for a song (400 bucks) on eBay listed as not working - although shown as powering on), because I thought it would be a fun project! Got it... -
Most expensive trim pots available
I recall a post a few years ago about a high-end trim pot, but don't recall the manufacturer. Anyone have more information?- Yamaha5000
- Thread
- ca1000 potentiometer yamaha
- Replies: 39
- Forum: Yamaha
-
C
Yamaha CR-600 recap, cleaning and adjustments, one channel sound fading resolved
Long story short (kinda) - I bought this unit in November as a faulty one. Turns on, no sound. Found out it was a blown fuse, but there's loud speaker pop when turning off. Left it as it was. Just learned to switch speakers to OFF before turning the unit off. Last week I noticed right channel... -
Sota Pyxi with my Yamaha GT-2000
I have found that a little change can have vast consequences. My little change occurred when I found a very nice Kenwood KD-550 back in September 2019 while on a weekend visit to Montreal. The lady I bought it from was selling off her deceased husbands turntable, and had agreed to hold onto it...- BilboBaggins
- Thread
- gt2000 pyxi sota yamaha
- Replies: 39
- Forum: Turntables
-
yamaha m-65 diagnostics and thermal, a tale of two yam's
the first amp seemed somewhat straightforward and was a 120v model, no broken output terminals. amp number two originally had a smoked channel although no chernobyl nor 3 mile island event transpired (yet, night is still young) perhaps a windscale. interesting info about the above metaphor...- sae-7125
- Thread
- big meters black gate blown channel circuit board glue class-a parts cooker international voltage selector m-65 thermal scan unstable dc bias yamaha
- Replies: 9
- Forum: Solid State
-
LF pretty amp with VU meters and plenty of power and good value
I only have my Pioneer AV-R to drive the B&W N803 at the moment. There's also my EL34 tube amp, but I'd rather not damage that baby, I guess (through using it constantly, I mean). Also, there's a little minime on the way, so the tube amp will likely have to disappear into storage for a couple...- mbphotox
- Thread
- amplifier hybrid integrated technics vincent vu-meter yamaha
- Replies: 25
- Forum: New Gear - Values
-
Yamaha RX-596 completely dead - and I'm stumped
So before I float this out to sea and set it on fire so it can go out in a blaze of glory, I thought I'd ask to see if anyone has run into a similar problem... Yamaha RX-596 receiver won't power on at all. No relay click, no nothing. Here's what I've done and checked so far... - The Sub power... -
Solid State Audio Tech in Atlanta?
Anyone have a lead on a reliable audio tech repair/maintenance guy anywhere in north Georgia? Currently I’m running Marantz, Pioneer and Technics ..but just picked up a Yamaha CR-2040 (estate sale find) that’s been sitting idle for a while and I would love to have it gone over and brought to...- christovw66
- Thread
- atlanta audio tech georgia marantz pioneer technics yamaha
- Replies: 2
- Forum: Solid State
-
CA-1000 Recognize this version?
- Yamaha5000
- Thread
- yamaha yamaha ca-1000
- Replies: 16
- Forum: Yamaha
-
Yamaha M-80 Transistor location tr119 and tr125
I'm working on an M-80 and believe TR119 and TR 125 are bad. I can't seem to find the location of them. I see them schematically but not in parts list nor on the main board which is what it looks like on the schematic. Any help is greatly appreciated! -
Vintage Audio Technician(s) in the Atlanta area?
Hey guys, getting ready to have a bit of reconditioning done on my Yamaha CR-2040 but have no leads on any reliable technicians in the Atlanta/north Georgia area. Any of y'all have someone you trust and can recommend? Preferably looking for someone that can handle tubes, silverface, and...- christovw66
- Thread
- kenwood marantz technics yamaha
- Replies: 2
- Forum: General Audio Discussion
-
M
Yamaha YP-D6 Service
Hey AK, Is there anyone with a VinylEngine.com account who would be willing to share with me the service manual for this beautiful Yamaha YP-D6 that I picked up from craiglist? would like to clean it up and recap https://www.vinylengine.com/library/yamaha/yp-d6.shtml I’ve had a hifi engine...- mmettej
- Thread
- restoration restoration help service manual yamaha yp-d6
- Replies: 8
- Forum: Turntables
-
J
Receiver upgrade advice
I’ve been using an old analog HK twin amp to run JBL Jubels. We mainly stream digital music through an audioengine B1. We also play play vinyl as well, though not as frequently. I want to upgrade to something newer that will drive the JBLs. We don’t really need all the home theater “stuff” but...- JaphyRyder
- Thread
- denon yamaha
- Replies: 7
- Forum: Home Theater & Video
-
H
Yamaha P2200 power amp - meter and lights cut out
Yamaha P2200 power amplifier. The right channel’s huge meter and its lights cut out occasionally. A tap or two on top of the amp fixes things. I’d like to enjoy a more permanent fix; can anybody pinpoint where to look for a poor (solder) connection? Also, I remember hearing that the black...- Hifibythekg
- Thread
- ic chips meter meter lamp p2200 power amp yamaha
- Replies: 5
- Forum: Yamaha
-
M
Yamaha A-1000 Repair and restore
Hi all, I have found this forum hunting around for info on this amp. After reading through the various A-1000 threads here, I have a bundle of tips and advice to follow and feel like the brains trust here is going to be life saving in my quest to restore this amp. A little back story.... I...
